#creativetoot #mastoart #witchystuff
So something I've been meaning to do forever is make, from scratch, a Delta Rune hanging to tack to my wall over my altar (and maybe other places?) I've taken a major step forward in accomplishing that, I'm very happy to report! I created a stencil of the Delta Rune on a 20' x 28' piece of thin cardboard by using a grid to hand-transfer a Delta Rune design (http://undertale.wikia.com/wiki/File:Delta_rune.svg in fact) to the cardboard. Then I cut the holes out with a sharp hobby knife and tested with a bit of spray paint on some dirty oriented-strand board out in the garden.
#creativetoot #mastoart #witchystuff
These photos show the start of the method. I used Inkscape to lay down a grid over the Delta Rune graphic (cropped to just the shapes inside the escutcheon) then drew that grid with 1" squares onto my cardboard. Then I copied as best as I could, eyeballing it, the pattern from the smaller grid squares to the larger ones.
https://witches.town/media/eYtZdMqQXhESjG6i8pM https://witches.town/media/lOD6wzIqUT6mB-1zo7k https://witches.town/media/uymesyq-eiINU0xjATo https://witches.town/media/O69lHfns7SQpcIYABSM
#creativetoot #mastoart #witchystuff
Slowly the pattern advances towards completion. This part of the task took about two hours all told.
https://witches.town/media/z6NaHA0htX8b5XapIis https://witches.town/media/SSWVn5brmoxP9O2Fz08 https://witches.town/media/xupw-8XhWbE_l4ukQr0 https://witches.town/media/IyXUWwBiHuvHv9Vt2fA
#creativetoot the next step: I'm preparing a solution of beeswax in turpentine which I intend to apply to white cotton fabric as a wax-resist for immersion dyeing. Sort of like batik, only I want the wax to go all the way into the fabric, not just lie on the surface.
#creativetoot next, applying the beeswax / turpentine solution, waiting for it to dry
turpentine may have been a bad choice of solvent. The wax is still gummy and it's possible there's just enough of some high-boiling residue in the turpentine that it's staying behind and keeping the wax from fully hardening.
I'm gonna try using things like floor polish and car wax as "resists", too. I mean, why not? I've got cheap fabric to burn on tests
#creativetoot #mastoart #witchystuff
And finally I cut all the holes out with an Exacto knife (note: a proper rubber cutting board, like seen in the second photo, makes this job much more pleasant than improvising with a piece of Masonite, as seen in the first photo.) Then I tested the finished stencil with some spray paint. ^_^
https://witches.town/media/-tWa4qRFx47gX1fQ43s https://witches.town/media/M9wcAWnLpCzw_5UNc2k https://witches.town/media/PKj4w8fiSj4f6l3WyHU https://witches.town/media/MLqu0GlGfB19OAQQlsg